To Make a Jeweled Bib Necklace, you have to decide on a shape for your bib necklace. You must choose a bib design or shape from the latter category to recreate in your project. After that, Draw your shape onto the piece of white paper with using a pencil and cut it out with the scissors. Then, Lay the pattern on top of a piece of the black felt. You should trace around the pattern with a piece of tailor’s chalk.
Next, stack the two pieces of felt on top of each other with the chalk-marked piece on top. You can pin the two pieces of felt together with placing a pin on the left and right edges. Forth, Cut the bib shape out with the scissors. You have to set the felt scraps to the side. After that, Trace the bib pattern piece onto the blank stencil sheet with a marker and Cut the bib shape out.
Then, Place one of the felt bib shapes on your work space. You need to apply hot glue to the shape with the hot glue gun. You must run the glue around the edge and a line across the middle. You should Put the plastic bib shape on top of the felt and Line the edges up so they are even. You can squeeze the pieces flat. Next, run a line of glue around the edge of the plastic.
You have to apply a line of glue across the middle of the plastic and Stack the other felt bib shape on top of the plastic. You need to Line the edges up evenly and squeeze flat. Forth, allow the glue cool for 10 minutes. After that, Place the jewels onto the bib. You must arrange them symmetrically if possible.
You should play with different design combinations until you are pleased with it. Then, Pick up a jewel and apply hot glue to the back of it. You can Place it onto the bib in its original place. You have to do this one by one until all jewels have been glued down. You need to allow the glue cool for 10 minutes.
Next, cut the ribbon into two 18-inch pieces. Forth, flip the bib over to the back. You must Place one end of a piece of satin ribbon at the right top edge of the bib. If you are unsure where to put the ribbon, you should hold the bib up to your neck and mark the spot with chalk. After that, Glue the edge of the ribbon to the bib. You should repeat for the left side with the other ribbon piece.
Then, Cut a small square from the felt scraps. You can Glue it on top of the end of one of the ribbons. You have to Cut out and glue another square for the other side. Last, secure the necklace around your neck with tying the ribbon into a neat bow with long ends.
Related posts: